* SVGA Drivers and Utilities for the 2500 RSX

The Super VGA Drivers enable the user to run Windows 3.1 under
the video controller's Super VGA screen modes on the TANDY 2500 RSX.

To run properly, the computer requires information about connected
devices and installed options. The computer stores this system
configuration information as well as the system date and time in
the CMOS RAM. The setup utility SETUPRSX.COM on this disk permits
the user to review and update the information stored in CMOS RAM.

The VGA Utilities provided on this disk are SETMODE.EXE, ACU.EXE,
and AVGA2CFG.COM. Using the SETMODE.EXE file, selection can be made 
from the standard and Super VGA modes the video circuitry supports. 
The ACU.EXE and AVGA2CFG.COM can be used to change the rate at which 
the screen updates are made to the display. More information on using 
these utilities is provided in the 2500 RSX User's Guide (page 35 
through 37).

This disk contains the following files--

   SETUPRSX.COM  AUTOEXEC.DSK  CONFIG.DSK    SETMODE.EXE
   ACU.EXE       AVGA2CFG.COM  README.TXT

   WIN31 <DIR>
   AVGA6256.DRV  AVGA8256.DRV  AVGA1024.DRV  AVGA816.DRV
   AVGA816.GR2   VGACOLOR.GR2  AVGA.3GR      VDDAVGA2.386
   VGA.3GR       OEMSETUP.INF  VGACOLOR.2GR  README.DOC


In order to obtain a printout of this README.TXT file, insert this
disk in Drive A, make sure that your printer is switched on, is on
line, and at the C:\> prompt, type the following command--

   PRINT A:README.TXT

and press <Enter>.


The installation instructions for these drivers are included in the
README.DOC file in the WIN31 directory on this diskette. In order to
obtain a printout of this README.DOC file, insert this disk in
Drive A, make sure your printer is switched on, is on line, and at
the C:\> prompt, type the following command--

   PRINT A:\WIN31\README.DOC

and press <Enter>. The installation procedure for these drivers is
also included on Page 38 of the 2500 RSX User's Guide. A chart of
Standard Video Modes is on Page 39 and chart of Super VGA modes is
on Page 40 of this User's Guide.


TO RUN SETUP FROM THIS DISK

1.  Start up your computer.

2.  Insert this disk into Drive A.

3.  At the C:\> prompt, type

      A:

    and press <Enter>.

4.  At the A:\> prompt, type

       SETUPRSX 
       
    and press <Enter>. The Setup Configuration Screen is displayed.

5.  Respond appropriately to the directions at the bottom of the
    screen to select options that reflect changes that you have
    made to the system configuration.

6.  Press <F2> to update the information in CMOS.

7.  Restart the computer.


NOTE:
"While reasonable efforts have been taken in the preparation of this
information to assure its accuracy, Tandy Corporation/Radio Shack
assumes no liability resulting from the use of the information
contained herein."
